Martha Falls

Lewis County, Washington

Detailed Info

Martha Falls is one of the more easily admired waterfalls in Mount Rainier National Park, though many, if not most visitors fail to grasp the true size of the falls. Dropping out of the basin containing Snow Lake, Unicorn Creek plunges and slides approximately 670 feet into Stevens Canyon in 12 major drops, depending on how you break it up. The first fall plunges about 55 feet but is very difficult to see. This is followed shortly by two smaller tiers about 15 and 20 feet each. The next fall is an eye-catching fan shaped drop of about 85 feet, which is then followed by a series of four smaller cascading falls which total about 65 feet in height. As the creek approaches the Wonderland Trail, it veils down back-to-back-to-back tiers of 49, 37 and 52 feet. After passing under the Wonderland Trail bridge the creek slides 56 feet down a smooth cascading drop then pitches directly into a shimmering powerful free-falling plunge of 121 feet. Because this series of falls occurs over a run of stream roughly one-quarter mile in length, there is some ancillary elevation change between each tier which makes up the remainder of the total 670 foot loss in elevation between the top and bottom of the falls.

Unfortunately, the entire falls cannot be seen collectively, due to the twisting nature of the gorge and the thick woods surrounding it. The final 121 foot plunge, as well as the trailside drop can be seen very easily. Most of the middle slides and cascades can be seen from the Stevens Canyon Road, but walking along the side of the road is necessary in order to be able to take pictures as there are no pullouts where the views are. The uppermost sections of the falls can be partially seen from a few places, but there isn't anywhere easily accessible to see them clearly. Despite all this Martha Falls is one of the best falls in the region, one of the taller falls in the state, and easily one of the most scenic in the park.

History and Naming

Martha Falls is the Official name of this waterfall.

Martha Falls was named in the late 1880's for Martha Longmire, wife of Elcaine Longmire, by her son Ben Longmire. The Longmire Mineral Springs resort was owned and operated by the family before the park was created.

Location & Directions

Coordinates:   46.76401, -121.69456
Elevation:   4083 feet
USGS Map:   Mount Rainier East 7 1/2"

Located in Stevens Canyon, between Paradise and Box Canyon, within Mount Rainier National Park. To reach the trailside portion of the falls, drive east on SR 706 for about 1/2 of a mile from The Bench (the extremely sharp hairpin turn in the road) or about 5 1/2 miles west from Box Canyon, to the Wonderland Trail. Follow the trail downhill for a long 2/3 of a mile to a bridge crossing Unicorn Creek, with the falls upstream. To see the rest of the falls, keep driving another 1/2 mile down Stevens Canyon to the Martha Falls viewpoint. It's unsigned, so watch for the falls across the canyon, and the large pullout with an interpretive sign.

View this location in Google Earth

Other Nearby Waterfalls

Additional Waterfalls which occur within 5 miles of Martha Falls
No additional waterfalls were found within 5 miles. Click the button below to browse the map instead.
Find More Nearby Waterfalls

By The Numbers

The information presented in this table is meant to help identify and clarify the physical aspects of the waterfall for comparative purposes. While we try to ensure this information is as accurate as possible, sometimes it will prove necessary to either estimate or flat out guess at certain characteristics where either enough information isn't readily available, is not known, or we were not able to confirm a given trait upon surveying. This information may be changed at any given time to ensure accuracy.

Total Height

The Total Height listed for the waterfall represents the difference in elevation from the top of the uppermost drop, to the bottom of the lowermost drop of the waterfall, including all stretches of interstitial stream in between. Stream between two tiers of a waterfall is counted in its overall height regardless of whether or not that section of the stream would be legitimately considered a waterfall on its own right, were it to be isolated. Waterfalls with only one drop will of have the height of only the single drop listed here.

Tallest Drop

The Tallest Drop figure represents the height of the largest single drop within a multi-stepped waterfall. Waterfalls with only one drop will have the total height of the waterfall repeated here.

Num of Drops

The Number of Drops in a waterfall is a tally of the total number of distinct drops which make up the waterfall. Stretches of interstitial stream in between two or more distinct drops of a single waterfall are NOT considered to be distinct drops of the waterfall unless the section of stream in question would otherwise qualify as a waterfall were it to be isolated.

Avg Width

The Average Width of the waterfall represents the breadth of the waterfall from bank to bank under typical flow conditions, or if the waterfall has been Cataloged, under the conditions which it was most thoroughly surveyed. Often this number will be approximated because of a lack of approachability to many waterfalls. We often utilize Google Earth to measure the width (where imagery is of sufficient quality and resolution to allow it.

Maximum Width

Maximum Width represents a hypothetical measurement of roughly how wide a waterfall could get during peak streamflow or flood conditions. For smaller waterfalls, this figure will generally not differ much from the Average Width measurement, but for broader waterfalls - especially those that feature a crest that isn't constricted - this figure can at times be consideraby larger. Like the Average Width measurement, this measurement will take into account the difference in width at the top and bottom of the waterfall as much as possible, but will often be made based on the width of the crest of th falls alone.

Pitch

The Pitch of a waterfall is an estimated - often very roughly - measure of the average slope or steepness of a waterfall. The Pitch figure only takes into account sections of stream which are actively falling. Pools or stretches of level stream in between two or more successive drops of the falls will not factor in this figure. As an example, a waterfall which features two truly free-falling leaps separated by several dozen yards of flat stream will have a Pitch of 90 degrees. Similarly, a waterfall with two drops separated by a pool, one with a true free-falling drop, and one with a Horsetail type fall will average the two, so while the Plunging drop has a Pitch of 90 degrees, if the Horsetail drop has a Pitch of 45 degrees, the total Pitch will be roughly 67 degrees.

Run

The Run of a waterfall is a measurement representing the total linear distance on the ground between the top and bottom of a waterfall. This figure is not often easy to establish with a high degree of precision and as such will often be estimated. Waterfalls with a longer Run will usually either be less steep, often cascading type waterfalls, or will feature multiple steps separated by shorter stretches of a more gradual gradient streambed.

Form

The system of classification of waterfall forms we use is a heavily modified derivative of the classifications outlined by Greg Plumb in his "Waterfall Lover's Guide to the Pacific Northwest" books. While plumb uses eight distnct forms, we wanted further granularity and opted to break down the hierarchy twofold: first based on the overall pitch of the waterfall, and then based on what shape the fall takes as it makes its descent. There are five primary Categories of falls in this system: Plunge, Horsetail, Steep Cascades, Shallow Cascades, and Rapids. Additional deliniation is then applied depending on characteristics such as the breadth of the falls, whether it splits into two or more channels, whether it falls in multiple successive drops, etc. For more information on our waterfall form classifications, see the Help page.

Watershed

The watershed which a waterfall occurs within, if it is specified, will be based on the ultimate distributary watercourse to the ocean. For example, Washington's Palouse Falls occurs along the Palouse River - which is a tributary to the Snake River, which is itself a tributary to the Columbia River, which ultimately enters the Pacific Ocean, so Palouse Falls would then fall within the Columbia River watershed. Streams which empty directly into the ocean, or into a minor basin which then empties to the ocean will often have this field left blank.

Stream

The name of the watercourse which the waterfall occurs along. If the watercourse is not known to have an officially or colloquially recognized name, this field is left blank.

Avg Volume

The volume of water present in the stream at the location of the waterfall. This is often the most difficult figure to pin down because accurately measuring streamflow is not a simple process. We will rely on USGS data as much as possible, and attempt to take into account seasonal fluctuations in stream levels if possible. There is no guarantee that this figure will be accurate, and in cases where there is no USGS data to use, it may be a very, very rough estimate at best.

Source

If known, the primary source of the watercourse which produces the waterfall will be listed here. This is helpful in determining whether a waterfall may flow more consistently during certain periods of the year - streams which originate in Springs, Lakes, or Glaciers will often flow more consistently throughout the year than those fueled by simply Runoff. The source of the stream may also be either unknown or undetermined.

Flow Consistency

A rough estimation of how many months out of the year the stream which produces the waterfall will actually hold water. The vast majority of waterfalls featured on this website will technically be truly perennial waterfalls (those that flow all year long), but some may see their flow dwindle greatly in the late summer months. This figure will not take into account the winter months when the waterfall may freeze, because in such cases the waterfall will very often be inaccessible. Entries which specify a Flow Consistncy of 12 Months should in general have an acceptable flow at any time of year (but may be better during certain periods - see below).

Best Flow

A general estimate of the best period of the year during which time the falls will be considered at optimal conditions, or flowing at their best. There may be variance within the range specified where the flow will be better or worse, but visiting at any time in the range specified (if available) will generally present the waterfall in its best light.

Close

Key

Cataloged Icon
Cataloged
Waterfalls which are Cataloged we have visited and surveyed in person. Statistical information should be quite accurate (for the most part), and exact measurements will often be available (information is not guaranteed to always be up to date). Detailed information, directions, and photographs will almost always be available.
Confirmed Icon
Confirmed
Confirmed Waterfalls are known to exist, should be relatively accurately mapped and geotagged, and the statistical information available will often be dependable. If height information is presented, it may be estimated but should be accurate. Directions will not likely be available.
Unconfirmed Icon
Unconfirmed
Unconfirmed Waterfalls are often marked on a published map, but we have yet to confirm the exact location and / or whether or not its stature is significant enough to qualify for listing in the database. Statistical information may be estimated and may be inaccurate. No directions.
Unknown Icon
Unknown
Waterfalls marked as Unknown are either suspected to exist based on heresay or a hunch, or we have received unverified information suggesting a waterfall may exist near the location provided but cannot corroborate it in any way. Geodata may not be accurate, the location may not be known at all, and statistical information will be estimated and highly inaccurate.
Inundated Icon
Inundated
Inundated Waterfalls have been submerged beneath lakes or reservoirs, usually a result of impoundment of a river behind a dam, and most often no longer functionally exist (there may be rare exceptions). We maintain records for these features out of historical importance.
Subterranean Icon
Subterranean
Though not common, some waterfalls can be found entirely underground within cave systems. Access to subterranean waterfalls can vary from easy via developed walkways to requiring a high level of extremely technical spelunking skill, including familiarity with ropework and a distinct lack of claustrophobia.
Disqualified Icon
Disqualified
Waterfalls which have been marked as Disqualified do not have the necessary stature or features to qualify as a legitimate waterfall according to our criteria. We will maintain records for entries with this status where the feature is well known and / or may have been historically referred to as a waterfall at some point in time.
Posted Icon
Posted
Posted Waterfalls are known to exist, and we may have a large amount of information associated with them, but are located on private property and are not legally accessible to the general public. Accessing waterfalls with this status should not be attempted without first being explicitly granted permission of the property owner.
Close

These ads help to pay our bills. Please consider whitelisting this domain in your adblocker to help keep this site running.